Zebsboards Forum

Yes, that's right. The plunger only controls the button input, lighting requires an output controller (ledwiz, pacled, one of my lighting boards, etc).

OK, it's the same as arcade button wiring. Common means use the same wire for one side of each button.

Hi,

Have you looked at the manual ?

ext/dmzx/fileupload/files/3671fe9144a88 ... 9006c1.pdf

viewtopic.php?f=27&t=3

According to the picture you provided previously you have the plunger set to use the Y axis on the board as the plunger, you need to use the z axis.

X axis (left right) and Y axis (forward backward) are the nudging axis. Change it to the z axis and you should be fine.

Is this a question for FP or VP? For FP you have to switch through the frontend as I've never been able to figure out the scripting for FP and the active x error is a common one. The default for the plunger at startup is indeed analog operation BUT once you switch it by serial command it will remain...

Zip file contains both 32bit and 64bit versions of the ZB compatible dll

click HERE to download

Initial release of DOFslave.exe file for interfacing Zebsboards products with Barnstorm's Pro Pinball Timeshock table

set your Steam Launch settings for ProPinball to :

q m3 fDOFslave

(m2 for 2 screen cabinets, m3 for 3 screen cabinets)

click HERE to download

This is the correct diagram for the firmware revision that you have ...

viewtopic.php?f=27&t=8

Unfortunately I haven't had a chance to update the A10K firmware to the newest version yet. Hopefully I will have a chance next week.

I'd go with the cheapest available option since they are all the same anyway. Looks like the Stern SPIKE motor is the cheapest at $79 Just connect the positive and negative wires on the existing motor to the positive and negative on the replacement. You'll probably be extending the existing wires. B...