I installed the plunger with x360ce, it worki but when i pull the plunger out doesnt work to the end. So the ball never can go to the end of the table.
Im runningin fx3? Do you know when i can do to make it right?
thank you
As I can no longer find the time to combat the continued attacks on the forums they will be closed over the next few weeks. Assistance emails can be sent to support@zebsboards.com however, please be patient as I am currently focused on efforts to get the store functioning properly. Thank you for your understanding.
plunger doesnt pull to the end in fx3
Re: plunger doesnt pull to the end in fx3
I'm assuming that in the control panel applet for the gamepad settings you are getting full draw registering in the scales at the top?
If yes then the issue is with calibrating the axis in the xbox360ce software. I haven't looked at that in some time as I don't officially support PBFX3 installations (don't have it, can't troubleshoot it).
If no then the plunger may have to be shimmed forward in the cabinet by a hair to allow for the complete range of motion.
If yes then the issue is with calibrating the axis in the xbox360ce software. I haven't looked at that in some time as I don't officially support PBFX3 installations (don't have it, can't troubleshoot it).
If no then the plunger may have to be shimmed forward in the cabinet by a hair to allow for the complete range of motion.