As I can no longer find the time to combat the continued attacks on the forums they will be closed over the next few weeks. Assistance emails can be sent to support@zebsboards.com however, please be patient as I am currently focused on efforts to get the store functioning properly. Thank you for your understanding.
Wires connection
Wires connection
Hello, i baught you plunger, but i do not have de knowledge to connect the wires, can you give me a help?
Thank you
Thank you
Re: Wires connection
Hi,
Have you looked at the manual ?
ext/dmzx/fileupload/files/3671fe9144a88 ... 9006c1.pdf
viewtopic.php?f=27&t=3
Have you looked at the manual ?
ext/dmzx/fileupload/files/3671fe9144a88 ... 9006c1.pdf
viewtopic.php?f=27&t=3
Re: Wires connection
Yes i did, but you have one wire for one button, in arcade we have 2 wires, and then you have the comon wire that i don't know where to connect, i'm sorry for my lack of knowlwdge, i searched the internet but i did not find any diagram of the wires connection. thank you (sorry for my english!!!)
Re: Wires connection
OK, it's the same as arcade button wiring. Common means use the same wire for one side of each button.
Re: Wires connection
Than you! If i connect to led buttons i'll have to put another board, that's right? Thank you!
Re: Wires connection
Yes, that's right. The plunger only controls the button input, lighting requires an output controller (ledwiz, pacled, one of my lighting boards, etc).
Re: Wires connection
Thank you, i hope i'll do it right!
Re: Wires connection
I'm sure that you will ....