Zebsboards Forum

Hello Zeb,

Hope you are fine my friend, it has been a long time.

I just received a Zeb plunger V3 from www.pinballshop.nl

i want to use it for the plunger, tilt and nudge primarily, the tilt and nudge are working, but not the plunger.

The Z Axis is not moving, i don't use the buttons for the moment, i'm on windows 10, driver seems ok, i tried to recalibrate but the axis is not moving
any idea on what to check next?

Cheers

Hi Arngrim,

Have you tried just the plunger itself without any harnesses plugged into it? All units are tested as I assemble them so the z axis was working when I shipped it out.

can you send me a pic of the circuit board to zeb@zebsboards.com? I'd like to make sure that there isn't any damage to the board.

You don't use the windows calibration feature with the V3 BTW, it auto calibrates at boot.