Keys work, plunger does not
Posted: Mon Sep 14, 2020 11:37 pm
Connected a few buttons (Start, Launch, Flippers, Magnasave), they all work BUT the plunger itself doesn't.
No motion in VPX. No motion on Z axis in Windows control panel -the plunger is recognized as a joystick no problem.
When I pull the plunger I see the potentiometer moving with its tab being pull by the slot in the 3D printed end cap.
Perhaps I am doing something wrong, or I am missing some setup step?
Thank you,
AR
No motion in VPX. No motion on Z axis in Windows control panel -the plunger is recognized as a joystick no problem.
When I pull the plunger I see the potentiometer moving with its tab being pull by the slot in the 3D printed end cap.
Perhaps I am doing something wrong, or I am missing some setup step?
Thank you,
AR