Hi
I have a V3 plunger and was wondering why it wasn’t registering. As per attached pic the metal slide mechanism has come out.
How was it sealed inside? Can you advise the best way to repair it?
cheers
As I can no longer find the time to combat the continued attacks on the forums they will be closed over the next few weeks. Assistance emails can be sent to support@zebsboards.com however, please be patient as I am currently focused on efforts to get the store functioning properly. Thank you for your understanding.
Plunger damaged
Plunger damaged
You do not have the required permissions to view the files attached to this post.
Re: Plunger damaged
This happens when the slide block and clip is installed backwards on the plunger.
By installing it backwards it reduces the physical distance available for the plunger to travel when released allowing that tab to strike the far end of the slot. The tab comes to a stop while the plunger rod continues to move forward which ultimately causes the tab to break off as in your picture.
The only way to fix that is to replace the potentiometer on the board.
By installing it backwards it reduces the physical distance available for the plunger to travel when released allowing that tab to strike the far end of the slot. The tab comes to a stop while the plunger rod continues to move forward which ultimately causes the tab to break off as in your picture.
The only way to fix that is to replace the potentiometer on the board.