As I can no longer find the time to combat the continued attacks on the forums they will be closed over the next few weeks. Assistance emails can be sent to support@zebsboards.com however, please be patient as I am currently focused on efforts to get the store functioning properly. Thank you for your understanding.

Plunger Push as ENTER

Post V3 Plunger Questions and Requests For Assistance here
Locked
MikeMaven
Posts: 2
Joined: Thu Oct 17, 2019 6:51 pm

Plunger Push as ENTER

Post by MikeMaven » Thu Oct 17, 2019 6:59 pm

I have v3 of the plunger. I do not have any controller currently to connect the Ball Launch input to an open negative output in order to cause the plunger to send an <Enter> when the plunger is pushed.

How can I get the plunger to send an <Enter> when the plunger is depressed? Can I wire the Ball Launch input to some other constant voltage?
Top
User avatar
Zebulon
Site Admin
Posts: 144
Joined: Fri Apr 19, 2019 9:28 pm

Re: Plunger Push as ENTER

Post by Zebulon » Sat Oct 19, 2019 8:04 am

Hi,

This is covered in the installation manual under the "Serial Control" section.

ext/dmzx/fileupload/files/3671fe9144a88 ... 9006c1.pdf

Basically you run a batch file that does the mode switching for you without needing to connect an external controller.
Top
MikeMaven
Posts: 2
Joined: Thu Oct 17, 2019 6:51 pm

Re: Plunger Push as ENTER

Post by MikeMaven » Thu Oct 24, 2019 12:32 pm

Thanks! I didn't have this manual- only an older one it seems. This gives a lot of helpful information :)

Really enjoying the plunger!
Top
User avatar
Zebulon
Site Admin
Posts: 144
Joined: Fri Apr 19, 2019 9:28 pm

Re: Plunger Push as ENTER

Post by Zebulon » Thu Oct 24, 2019 12:37 pm

No worries,

All of the documentation for everything is posted at the top of the board here in the Product Information Category
Top
Locked

Return to “V3 Support”