I have v3 of the plunger. I do not have any controller currently to connect the Ball Launch input to an open negative output in order to cause the plunger to send an <Enter> when the plunger is pushed.
How can I get the plunger to send an <Enter> when the plunger is depressed? Can I wire the Ball Launch input to some other constant voltage?
As I can no longer find the time to combat the continued attacks on the forums they will be closed over the next few weeks. Assistance emails can be sent to support@zebsboards.com however, please be patient as I am currently focused on efforts to get the store functioning properly. Thank you for your understanding.
Plunger Push as ENTER
Re: Plunger Push as ENTER
Hi,
This is covered in the installation manual under the "Serial Control" section.
ext/dmzx/fileupload/files/3671fe9144a88 ... 9006c1.pdf
Basically you run a batch file that does the mode switching for you without needing to connect an external controller.
This is covered in the installation manual under the "Serial Control" section.
ext/dmzx/fileupload/files/3671fe9144a88 ... 9006c1.pdf
Basically you run a batch file that does the mode switching for you without needing to connect an external controller.
Re: Plunger Push as ENTER
Thanks! I didn't have this manual- only an older one it seems. This gives a lot of helpful information
Really enjoying the plunger!
Really enjoying the plunger!
Re: Plunger Push as ENTER
No worries,
All of the documentation for everything is posted at the top of the board here in the Product Information Category
All of the documentation for everything is posted at the top of the board here in the Product Information Category