Page 1 of 1
Plunger Push as ENTER
Posted: Thu Oct 17, 2019 6:59 pm
by MikeMaven
I have v3 of the plunger. I do not have any controller currently to connect the Ball Launch input to an open negative output in order to cause the plunger to send an <Enter> when the plunger is pushed.
How can I get the plunger to send an <Enter> when the plunger is depressed? Can I wire the Ball Launch input to some other constant voltage?
Re: Plunger Push as ENTER
Posted: Sat Oct 19, 2019 8:04 am
by Zebulon
Hi,
This is covered in the installation manual under the "Serial Control" section.
ext/dmzx/fileupload/files/3671fe9144a88 ... 9006c1.pdf
Basically you run a batch file that does the mode switching for you without needing to connect an external controller.
Re: Plunger Push as ENTER
Posted: Thu Oct 24, 2019 12:32 pm
by MikeMaven
Thanks! I didn't have this manual- only an older one it seems. This gives a lot of helpful information
Really enjoying the plunger!
Re: Plunger Push as ENTER
Posted: Thu Oct 24, 2019 12:37 pm
by Zebulon
No worries,
All of the documentation for everything is posted at the top of the board here in the Product Information Category