EZInstall Kit - ZB Controller - 32 output versions
Posted: Sun Apr 21, 2019 11:15 am
Kits shipping after October 1st, 2018 use the new ZB controller. Physical installation and mounting of the kit remains the same as the V2 R1 kit and the software config is as follows.
For existing DOF installations:
1. Download the ledwiz.dll file click HERE to download
2. Extract the dll file and right click on the the extracted file in the folder it created.
3. Left click on the properties selection in the menu that pops up.
4. At the bottom of the properties window that opens, tick the box that unblocks the file if necessary.
5. Close the window and replace the ledwiz.dll in the directoutput folder on your computer with the unblocked one from the extraction folder.
For Installation of DOF from scratch:
Download and run the installer from either the link below or directly from the source mjrnet.org/pinscape/dll-updates.html . This will install mjr's Grander Unified R3++ build of DOF. All ZB contoller boards are natively supported by this build and will be auto-detected.
mjr Grander Unified DOF R3++
For existing DOF installations:
1. Download the ledwiz.dll file click HERE to download
2. Extract the dll file and right click on the the extracted file in the folder it created.
3. Left click on the properties selection in the menu that pops up.
4. At the bottom of the properties window that opens, tick the box that unblocks the file if necessary.
5. Close the window and replace the ledwiz.dll in the directoutput folder on your computer with the unblocked one from the extraction folder.
For Installation of DOF from scratch:
Download and run the installer from either the link below or directly from the source mjrnet.org/pinscape/dll-updates.html . This will install mjr's Grander Unified R3++ build of DOF. All ZB contoller boards are natively supported by this build and will be auto-detected.
mjr Grander Unified DOF R3++