V1 Plunger Installation Instructions

Archived information on the V1 Plunger will be kept here but the V1 is officially at the EOL stage with regard to ongoing support.
Locked
User avatar
Zebulon
Site Admin
Posts: 109
Joined: Fri Apr 19, 2019 9:28 pm

V1 Plunger Installation Instructions

Post by Zebulon » Sat Apr 20, 2019 11:33 am

Installation Manual

V1 Plunger manual click HERE

Button wiring info for the gamepad only version is:

Image

Button wiring info for the keyboard version is:

Image

The diagrams are hard to read so here is the pinout chart for the keyboard firmware:

Lower connector (as pictured above) regular functions:

Right magnasave (R_ctrl), Start (1), Left Flipper (L_Shift), Right Flipper (R_Shift), Left magnasave (L_CTRL), End (e)

Upper connector:

Launch Ball (Enter), Coin (5), Joystick button 1, joystick button 2, Alt_button Switch trigger, ZB Launch feature trigger


Lower Connector alt functions (when alt-button wired is grounded)

Service menu CANCEL (7), Coindoor OPEN (END), Volume DOWN (+), Volume UP (-), Service Menu ENTER ( 0 ), Service menu DOWN ( 8 )

Upper connector alt functions:

Service menu UP (9), N/A, Joystick button 3, Joystick button 4



Volume buttons are reversed in diagram and controller USB cable now comes out beside the common wire.

Locked