Wires connection

Post V3 Plunger Questions and Requests For Assistance here
Post Reply
munhas
Posts: 4
Joined: Tue Feb 25, 2020 10:45 am

Wires connection

Post by munhas » Tue Feb 25, 2020 10:50 am

Hello, i baught you plunger, but i do not have de knowledge to connect the wires, can you give me a help?
Thank you

User avatar
Zebulon
Site Admin
Posts: 116
Joined: Fri Apr 19, 2019 9:28 pm

Re: Wires connection

Post by Zebulon » Tue Feb 25, 2020 11:26 am


munhas
Posts: 4
Joined: Tue Feb 25, 2020 10:45 am

Re: Wires connection

Post by munhas » Tue Feb 25, 2020 5:05 pm

Yes i did, but you have one wire for one button, in arcade we have 2 wires, and then you have the comon wire that i don't know where to connect, i'm sorry for my lack of knowlwdge, i searched the internet but i did not find any diagram of the wires connection. thank you (sorry for my english!!!)

User avatar
Zebulon
Site Admin
Posts: 116
Joined: Fri Apr 19, 2019 9:28 pm

Re: Wires connection

Post by Zebulon » Tue Feb 25, 2020 6:39 pm

OK, it's the same as arcade button wiring. Common means use the same wire for one side of each button.

Image

munhas
Posts: 4
Joined: Tue Feb 25, 2020 10:45 am

Re: Wires connection

Post by munhas » Wed Feb 26, 2020 3:33 am

Than you! If i connect to led buttons i'll have to put another board, that's right? Thank you!

User avatar
Zebulon
Site Admin
Posts: 116
Joined: Fri Apr 19, 2019 9:28 pm

Re: Wires connection

Post by Zebulon » Wed Feb 26, 2020 7:33 am

Yes, that's right. The plunger only controls the button input, lighting requires an output controller (ledwiz, pacled, one of my lighting boards, etc).

munhas
Posts: 4
Joined: Tue Feb 25, 2020 10:45 am

Re: Wires connection

Post by munhas » Wed Feb 26, 2020 8:29 am

Thank you, i hope i'll do it right!

User avatar
Zebulon
Site Admin
Posts: 116
Joined: Fri Apr 19, 2019 9:28 pm

Re: Wires connection

Post by Zebulon » Wed Feb 26, 2020 9:04 am

I'm sure that you will .... :D

Post Reply