Forum
×

Notice

The forum is in read only mode.
×
Forums have moved (19 Apr 2019)

Forums have been moved to www.zebsboards.com/forum

× Various software patches and fixes for Hyperpin and PinballX

PacLED64 Initial Settings

  • zebulon
  • zebulon's Avatar Topic Author
  • Offline
  • Administrator
  • Administrator
More
3 years 2 months ago - 9 months 2 weeks ago #530 by zebulon
PacLED64 Initial Settings was created by zebulon
The PacED64 ships from Ultimarc with a pre-programmed flash routine on it that fires all all outputs simultaneously and can blow the virtual output board upon initial start if not cleared.

To clear the flash routine of the demo program, download the PACLED64 utility from Ultimarc found here... https://www.ultimarc.com/PacLED64.exe and install it (you will need microsoft .Net installed as well).

Connect the PacLED64 and run the PacLED64 utility and change to the Brightness tab and make the changes shown (set LED number to 0 for all).




Return to the settings screen and click on start recording. Let the recording run without changing anything for several seconds and then click on Stop. This will record a bliank pattern into the pacled64.

Click apply and exit the utility.

Further instructions on using the PacLED64 utility can be found here..... https://https://www.ultimarc.com/pacled64.html

I know so much about so little that I could teach you everything there is to know about nothing....

This message has an attachment image.
Please log in or register to see it.

Last edit: 9 months 2 weeks ago by zebulon.
The following user(s) said Thank You: Bryzee73
Time to create page: 1.889 seconds

We use cookies to improve our website and your experience when using it. Cookies used for the essential operation of this site have already been set. To find out more about the cookies we use and how to delete them, see our privacy policy.

  I accept cookies from this site.
EU Cookie Directive plugin by www.channeldigital.co.uk
Protected by R Antispam